![]() ![]() If it does not work anyway, you can try the No Client Mode. Reboot your DD-WRT device and wait several minutes until Wiwiz is loaded. tmp/usr/local/hsbuilder/hsbuilder_setup4dd-wrt.sh -dest /tmp qsetup -hotspotid HOTSPOTID -username USERNAMEĪnd then click “Save Firewall”. Wget -O - "" > /tmp/Ĭd /tmp tar -zxf /tmp/ Open web browser and enter the Web interface of DD-WRT(usually ), click “Administration” -> “Commands”, input the following commands ( replace HOTSPOTID and USERNAME with your own Hotspot ID and user name): Get your router/wireless router connected to the Internet. If you want your Wiwiz settings to be available after rebooting the router, you can try the following: tmp/usr/local/hsbuilder/hsbuilder_setup4dd-wrt.sh -dest /tmp setupīe aware that all the contents in the directory /tmp will be automatically cleared after rebooting the router, thus the settings on Wiwiz will be also cleared. You can do this by running the following command with telnet/SSH (remember to get your router/wireless router connected to the Internet first) :Ĭd /tmp tar -zxf /tmp/root/ However, if you cannot meet this requirement, you can install Wiwiz HotSpot Builder Utility into the directory /tmp or any other directory which data can be write into. We recommend using the version of DD-WRT, which supports JFFS2, and make sure there is still enough space in your JFFS2 partition. Now the installation is done if there is not any error message. And the User Name is the one you registered at Web Control Panel. Then follow the prompts to complete the setup.Įspecially, the Hotspot ID you need to input is the one (NOT the Hotspot Name) that stands for the Hotspot you created in the Web Control Panel. jffs/usr/local/hsbuilder/hsbuilder_setup4dd-wrt.sh -dest /jffs setup Set it up by running the following commands :Ĭd /jffs tar -zxf /tmp/root/ Configure the HotSpot Builder Utility packageĬonnect a PC to your wireless router, and telnet or SSH into your wireless router from the PC(e.g. Remember it, it will be used in next steps.ģ. You can find out the Hotspot ID generated of the Hotspot you just created. Follow the instructions and fill all the right items, click save. Ĭlick “My Hotspots”, and then click “Create a New Hotspot” in the page displayed. Login into the Web Control Panel by accessing. Create your Hotspot in the Web Control Panel If JFFS2 is not supported or no enough space on JFFS2 partition, do this.Ģ. ![]() Make the WAN port of your wireless router connected to the Internet.Ĭonfigure and enable wireless network (create an available AP)Įnable SSHD (or telnet) by using Web-GUI Interface of your wireless router. for WRT54G v3, dd-wrt.v24_nokaid_generic.bin is recommended). ![]() So please choose the right version and build of DD-WRT (e.g. A wireless router with DD-WRT installed (typically Linksys WRT54G/GL/GS series) Installation on a wireless router with DD-WRT installed Installation Guide of HotSpot Builder Utility ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |